Nissan Skyline R34 GTR

Some of you may remember this R34 GTR, we had it in for a coolant leak, which unfortunately turned out to be a cracked block.

So a second hand N1 24u rb26 block was purchased.

We reused most of the Nitto 2.7 kit, the pistons were replaced, the crank had a very minor polish. When we came to reassemble the bottom end, we measured the crank to bearing gaps using plastigauge (can be seen in the pictures) and ring gaps were measured and adjusted If tolerances were to small. Now all the tolerances and gaps are perfect we proceeded to built the engine up using only the best components for reliability when this GTR is tearing up the track!

Once the engine was fitted, we run it in properly with religious engine oil changes, with the correct oil.

Now for mapping. And who better than Romain at Syvecs. He did a brilliant job with this car maximising engine performance and reliability. The car made just under 600 bhp after the engine was mapped, due to the turbos underperforming, so this is to be continued! With new turbos, this car will make 600bhp+!

Gary has his car back for now, until next time

Comments are closed.

Perfect Touch Performance Ltd

Perfect Touch Performance Ltd

Unit 1 Hannah Nursery,
Sewardstone Road,
London
E4 7RG
0208 191 7916
01992 443900
 
 
Registered in England and Wales: 07786097
VAT No.: GB770746314
 
bosch_automotive_trainedtrust-my-garage-135which-trusted-trader-135Mobil-1-service-centre-135

Recent Posts

Subaru Impreza WRX STI Hatchback Front Mount Intercooler

This Subaru Impreza Hatchback came to us for some performance upgrades including a front mount inter

November 3, 2018 read more

Ford Mustang Rear Subframe Bush Collars and Wheel Alignment

This Mustang was brought in to have some Steeda UK parts fitted, including wheel spacers, rear bumpe

October 26, 2018 read more
audi-80 bmw-80 jaguar-80 mercedes-benz-80 mitsubishi-evo-200 nissan-gtr-200 range-rover-80 subaru-impreza porsche-80

This website uses cookies to give you the best experience. Agree by clicking the 'Accept' button.